1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Two Factor Authentication is now available on BeyondUnreal Forums. To configure it, visit your Profile and look for the "Two Step Verification" option on the left side. We can send codes via email (may be slower) or you can set up any TOTP Authenticator app on your phone (Authy, Google Authenticator, etc) to deliver codes. It is highly recommended that you configure this to keep your account safe.

AutoCad and UnrealEd

Discussion in 'Mapping' started by Butcher, Nov 14, 1999.

  1. Butcher

    Butcher New Member

    Joined:
    Nov 13, 1999
    Messages:
    13
    Likes Received:
    0
    Can you shape a brush in AutoCad then import it into UnrealEd? What scale? File types?
    Useing AutoCad release12 for dos.
    Also 3DS v2
    Any advice?? Thx..
     
  2. Aridale N. Belmont

    Aridale N. Belmont New Member

    Joined:
    Nov 9, 1999
    Messages:
    87
    Likes Received:
    0
    Load UEd and check the import types and export one of those types of your brush from CAD and try it on an empty test level. Worse thing that can happen is UEd will crash or lockup. Im pretty sure you can do it.



    [​IMG]
    Ari
     
  3. Wanderer

    Wanderer New Member

    Joined:
    Jul 7, 2000
    Messages:
    1,334
    Likes Received:
    0
    Never used Autocad so the best thing to do is to make a test brush in Autocad. Make it, export it as a .dxf file (should be the default format).

    Now in UnrealEd you'll have to import it by clicking on Brush=>Import
    Then find you're brush. See how it works in UnrealEd and see what size it is. That's the best way to figure out the conversion scale.
     
  4. Githianki

    Githianki New Member

    Joined:
    Nov 11, 1999
    Messages:
    71
    Likes Received:
    0
    I have been using Lightwave to do a lot of brushes lately and exporting them via .dxf

    Here are a few tips besides Wanderer's scaling one:

    1)Remember to keep the number of polygons in the brush below 500 or you WILL lose data when importing into UnrealED. Use stats or info commands to count the polys in your object to keep to this before you save to .dxf.

    2)Try to use only closed meshes. This means that the 'interior' of the brush should be totally enclosed by polygons, all of which should face either 'inwards' or 'outwards'(avoid combos in a brush). A non-enclosed mesh would be a terrain sheet/grid for example. It has two sides but encloses no volume. A closed mesh encloses a volume with no leaks.

    3)Be sure that you reset the red master brush in Unreal for location,rotation and scale before you import the .dxf brush. This is VERY IMPORTANT. Otherwise you might end up with problems using those tools later on the imported brush.

    Basically, you should reset, import, then adjust the brush using those tools to get a good working size. If you have already figured out a good scale to build at in AUTOCAD, you won't need to adjust size. After getting the brush set up, save it, then clear everything again and reload the saved brush. Now you should have a brush, properly sized, rotated, etc. that you can use without any problems.
     

Share This Page