|
24th Oct 2001, 05:17 PM
|
#1 |
|
Insomaniac
Join Date: Jan. 6th, 2001
Location: Hiding from Swedix
Posts: 255
|
Spooky 'malfunkction' in UEd2
this happened after a couple of hours of mapping.. suddenly the scale when i add a new cube or a sheet into my world is multiplyed by ten!
this only affects the Width size, so when i set it to 256 it will be made as 2650! kinda slows down the work  anyone ever had this before? edit: almost forgot, this only happends on the map im making now. i can load up an old map or start again from an old save of this map and the scale is correct, but its f00ked again if i load up the latest rebuild of this map |
|
|
|
24th Oct 2001, 05:24 PM
|
#2 |
|
Level Designer
Join Date: Oct. 2nd, 2000
Location: Atlantis
Posts: 2,740
|
Have you scaled the builder brush?
(Try doing a Transform Permanently or a Reset Scale)
__________________
Chris Toth ------------- Chris@message.hu 
|
|
|
|
|
24th Oct 2001, 05:51 PM
|
#3 |
|
Insomaniac
Join Date: Jan. 6th, 2001
Location: Hiding from Swedix
Posts: 255
|
fast reply
 Found the Transform Permanently command and it did the trick! i dont have 2 kill myself now  thx for the help
Last edited by Angel of Dath; 24th Oct 2001 at 06:23 PM. |
|
|
|
|
25th Oct 2001, 11:46 AM
|
#4 |
|
Level Designer
Join Date: Oct. 2nd, 2000
Location: Atlantis
Posts: 2,740
|
Oh, and don't forget to read the Editing FAQ on the top of the board. It might save you a lot of time in the future...
__________________
Chris Toth ------------- Chris@message.hu
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
