UE2 - UT2kX Jump Pad emitters

  • Two Factor Authentication is now available on BeyondUnreal Forums. To configure it, visit your Profile and look for the "Two Step Verification" option on the left side. We can send codes via email (may be slower) or you can set up any TOTP Authenticator app on your phone (Authy, Google Authenticator, etc) to deliver codes. It is highly recommended that you configure this to keep your account safe.
T

Turbo K

Turbo K
Feb 8, 2010
105
0
0
California
I have read some tutorials, but I still can't figure out how to make the jump pads and teleporters look like the ones in the game. Do any of you know where a very basic walkthru would be?
 
R

rmcollins3

AKA "Doublez-Down"
Mar 18, 2000
999
0
0
Melbourne, FL
utunlimited.beyondunreal.com
Am I correct in assuming you have opened up stock maps in the editor and looked at those? Just look at all of those properties and adjust them how you see fit. Or if you're not worried about, just copy/paste the emitter into your map and make fine tune adjustments there.
 
T

Turbo K

Turbo K
Feb 8, 2010
105
0
0
California
I copied the emitters from AS-Junkyard and they work.
The problem is now they all face one direction instead of where I want them to point.
 
You must log in or register to reply here.
Top Bottom