Benchmark in UT

[Gev]

How do I use UT to benchmarks.......I know there is a way and that I have to DL a small file but how and where?

[BirddoG]

here at puf they tend to use the intro as a good judge for frames

let it go through once then turn on timedemo mode



Meh, Back to play with Joanna.

[Gev]

How do I turn on timedemo-mode?

[Necroth]

time on the intro of UT the ~ key, and enter timedemo 1, otherwise enter open cityintro and hit esc twice


Nominated by PuF as King of LPB's
Defense and Freelance player for [Ci]

Send articles/rants/editorials to The Soundoff , home of the world-famous Llama Farm!

[Clayeth]

Ok, I know we usually use the intro, but I've noticed something recently. I reinstalled the game without any mods/skins etc. And gained quite a bit of speed in single player games. I was able to raise the resolution one notch, and keep the same FPS. However, this didn't effect the fps of the flyby intro.

If anyone knows where to get the file Gev was talking about, let me know, because I don't know that the flyby is that good of a benchmark.

[Gev]

Finally I figured out how to do. Run the intro and press tab>>>>write timedemo 1 [enter]>>>>write Demoplay utbench [enter] When finished you have to press Æ but in other countries than Denmark you do not have that letter so I don't know what should be pushed to activate the result. The first time no result will appear but then just try again and the result appears.

To use this method you have to install a file called Utbench.dem in your [gamedir]/system the file can be downloaded <a href="http://www.3dcenter.de/downloads/index.html#timedemos" target=_"blank">here</a>. The site is in German but i'm sure you'll find out!

[Gev]

Well I did not realized that HTML codes does not work here so here's the link, 3D-Center