Anyone ever wanted to make Tarquin's torus without a hole in the middle? Then it's @|#{§! that the Tubethickness must be SMALLER than the Outerradius. It would be better if the Tubethickness had to be SMALLER OR THE SAME as the Outerradius.
The solution is to change in the script the line
if( TubeThickness >= OuterRadius )
return BadParameters("Thickness must be smaller than Outer Radius");
into
if( TubeThickness > OuterRadius )
return BadParameters("Thickness must be smaller than Outer Radius");
and compile changed
(to get into the script, first deselect Actor classes only and then go to brushbuilders)
You can even remove the line, then you can make torusses with a larger Tubethickness than the Outerradius. However these are quite ugly and BSP-y
Tarquin, please think about this in your next release... Or do I have an old release and do you have changed this already?
Here's a screen
The solution is to change in the script the line
if( TubeThickness >= OuterRadius )
return BadParameters("Thickness must be smaller than Outer Radius");
into
if( TubeThickness > OuterRadius )
return BadParameters("Thickness must be smaller than Outer Radius");
and compile changed
(to get into the script, first deselect Actor classes only and then go to brushbuilders)
You can even remove the line, then you can make torusses with a larger Tubethickness than the Outerradius. However these are quite ugly and BSP-y
Tarquin, please think about this in your next release... Or do I have an old release and do you have changed this already?
Here's a screen