Well I've been absent from the board for a while. Missed everyone!
My new computer arrived today and is a PowerMac G4. I've switched from PC. I hope I don't regret it!
The point of this post? Well I haven't had time to look through all the boards posts yet (I am at work) but was wondering if anyone has any Mac specific tips.
My system is:
867 Mhz G4
128MB RAM (until later tonight)
60GB drive
64MB GeForce 3
Since I am so new to the Mac I didn't know what to expect. I bought UT when I ordered the machine and during setup it detected RAVE. Is this comparible to OpenGL? Does UT run in OpenGL on the Mac? I'll be looking for OpenGL drivers later.
Any thoughts are welcome!
AmigaOne|PuF
My new computer arrived today and is a PowerMac G4. I've switched from PC. I hope I don't regret it!
The point of this post? Well I haven't had time to look through all the boards posts yet (I am at work) but was wondering if anyone has any Mac specific tips.
My system is:
867 Mhz G4
128MB RAM (until later tonight)
60GB drive
64MB GeForce 3
Since I am so new to the Mac I didn't know what to expect. I bought UT when I ordered the machine and during setup it detected RAVE. Is this comparible to OpenGL? Does UT run in OpenGL on the Mac? I'll be looking for OpenGL drivers later.
Any thoughts are welcome!
AmigaOne|PuF