Thanks for the advice about my last post!
I had yet to learn how to punch holes, I know it has something to do with makeing a brush where to hole is to be, and then intersecting (de-intersecting?) and the either adding or subtracing, but I've yet to get it to work right.
I had at one point made a sqare room (a hollow brush) with a hole, but it seemed to an "edge" around it on the inside and out side of the room.
What should I be doing? Also, after I made the hole, I could not place any playerstart actors! Is this because the level was not fully enclosed?
again thanks for the help earier!
I had yet to learn how to punch holes, I know it has something to do with makeing a brush where to hole is to be, and then intersecting (de-intersecting?) and the either adding or subtracing, but I've yet to get it to work right.
I had at one point made a sqare room (a hollow brush) with a hole, but it seemed to an "edge" around it on the inside and out side of the room.
What should I be doing? Also, after I made the hole, I could not place any playerstart actors! Is this because the level was not fully enclosed?
again thanks for the help earier!