GPF when running INF 2.82

UTProphet · 30th Dec 2000, 01:36 PM

Alright, it was working fine since it came out. I must have done something wrong cause all of a sudden it stopped working. Now I get this error. Can anyone help me out? Thanks...

General Protection Fault!

History: WWizardDialog::OnBack <- WWizardDialog::Advanced <- WDialog::OnInitDialog <- WWizardDialog::OnInitDialog <- WStartupWizard::OnInitDialog <- WM_INITDIALOG <- WWindow::WndProc <- WWindow::StaticProc <- WDialog:

oModal <- ConfigUI <- InitEngine

UTProphet
Jeremy Rosenberg

UTProphet · 30th Dec 2000, 02:28 PM

All fixed. It appears that if you don't shut down UT properly, INF isn't programmed to give you that window that asks to Run, Change 3D Device, etc. I opened UT, chose Run, exited, then ran INF and it worked.

You should really fix that bug...

UTProphet
Jeremy Rosenberg

30th Dec 2000, 01:36 PM	#1
UTProphet Trial By Fire Join Date: Dec. 8th, 2000 Posts: 509	GPF when running INF 2.82 Alright, it was working fine since it came out. I must have done something wrong cause all of a sudden it stopped working. Now I get this error. Can anyone help me out? Thanks... General Protection Fault! History: WWizardDialog::OnBack <- WWizardDialog::Advanced <- WDialog::OnInitDialog <- WWizardDialog::OnInitDialog <- WStartupWizard::OnInitDialog <- WM_INITDIALOG <- WWindow::WndProc <- WWindow::StaticProc <- WDialog:oModal <- ConfigUI <- InitEngine UTProphet Jeremy Rosenberg

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

30th Dec 2000, 02:28 PM	#2
UTProphet Trial By Fire Join Date: Dec. 8th, 2000 Posts: 509	All fixed. It appears that if you don't shut down UT properly, INF isn't programmed to give you that window that asks to Run, Change 3D Device, etc. I opened UT, chose Run, exited, then ran INF and it worked. You should really fix that bug... UTProphet Jeremy Rosenberg