Does anyone here own an Antec SX1030/1040 case?

  • Two Factor Authentication is now available on BeyondUnreal Forums. To configure it, visit your Profile and look for the "Two Step Verification" option on the left side. We can send codes via email (may be slower) or you can set up any TOTP Authenticator app on your phone (Authy, Google Authenticator, etc) to deliver codes. It is highly recommended that you configure this to keep your account safe.
Hadmar

Hadmar

Queen Bitch of the Universe
Jan 29, 2001
5,558
42
48
Nerdpole
Sweet, now I finaly know who produced my case (SX1240), thanks!

I have no problems to put a 5 1/4" device in though.

It's exactly like the manual says:

5.25" Device Installation
1. Take off the plastic drive bay covers and metal plates as described above.
2. Take two pieces of the Tension Clips and mount them onto the sides
of the 5.25" device. Make sure the metal portion is angled on the
outside and facing forward.
3. Slide the device into the drive bay until you hear a click.
4. Mount the other devices accordingly. Connect a large 4-pin white
connector from the power supply to the male 4-pin connector on each
of the devices.
Click to expand...
 
RogueLeader

RogueLeader

Tama-chan says, "aurf aurf aurf!"
Oct 19, 2000
5,314
0
0
Indiana. Kill me please.
I followed the directions, but it won't snap into place. The drive slides in most of the way, but before going all the way in it gets stuck. Tell me this; is the metal part supposed to be near the front or rear of the drive? Their vague instructions ("angled on the outside and facing forward"?) don't make it clear to me. Right now I have the metal at the back.
 
You must log in or register to reply here.
Top Bottom