Adding Pools in UED2

[Mclarenlover]

Does anyone know how to add water to a level? I know how to add the special water brush... but how do I get the actual water in the level?

[Katze]

Go to Actors -->Info-->ZoneInfo-->Waterzone and place it within the boundaries of your water pool. Make sure it is inside the area where your water is.

[Mclarenlover]

Thanks a lot man.

[Dark_Outlaw lPuFl]

AND MAKE SURE THE ZONE IS SEALED WELL!!! if not, you flood your whole level and it sucks...

you might say..."well, duh, ******* " but watch out...sometimes its tricky. make sure you have your grid on...

[Dark_Outlaw lPuFl]

AND MAKE SURE THE ZONE IS SEALED WELL!!! if not, you flood your whole level and it sucks...

you might say..."well, duh, ******* " but watch out...sometimes its tricky. make sure you have your grid on...

[Mclarenlover]

Yeha, I figured that out after a few times Outlaw... hehehe... I just covered it with a sheet, intersected it, and made it non-solid and two-sided, gave it a water texture, and shabam.. works great... Thatnks anyway tho.