When adding a seperate hard drive dedicated to run only UT and Win98 Swap file... which of the following(or any alternate methods you might know) would perform the fastest?
1)adding it as a SLAVE to your C:\primary drive on the same IDE ribbon (ata/66/both 7200)
2)adding it as a MASTER drive on the secondary ribbon
3)adding it as a SCSI drive (68 pin) using an AdvanSys PCI UW controller (SCSI is fast but still confined to PCI bus ..ya think?) hmmm....??
1)adding it as a SLAVE to your C:\primary drive on the same IDE ribbon (ata/66/both 7200)
2)adding it as a MASTER drive on the secondary ribbon
3)adding it as a SCSI drive (68 pin) using an AdvanSys PCI UW controller (SCSI is fast but still confined to PCI bus ..ya think?) hmmm....??